White Knight Ultra Pave^® Concrete Etcher

How To Apply

1. PREPARATION

• Dissolve 1kg of White Knight Ultra Pave Concrete Etcher in 10 litres of clean water in a plastic bucket by pouring granules slowly into water while stirring.
• Stir until all granules have dissolved.
• Pour the solution into a plastic watering can

2. APPLICATION

• Use a plastic watering can to evenly pour the solution over the concrete and then scrub with a stiff bristle broom. Reaction of the White Knight Ultra Pave Concrete Etcher with concrete is shown by bubbling or foaming.
• Allow the White Knight Ultra Pave Concrete Etcher solution to react with the concrete for 2 minutes. If the Concrete Etcher solution does not foam a clear coating on the surface may be present. The clear coating must be removed mechanically before etching.
• Hose surface before it dries using a strong water jet with clean water to remove excess etcher, salts and other residues.
• Check the surface has slightly roughened. It should feel like 180# sandpaper. If not, repeat the etching process.

3. COVERAGE

10 litres of solution will treat approximately 40m² of concrete, depending on the porosity of the surface.

4. CLEAN UP

Clean equipment with water immediately after use.

5. SAFETY & FIRST AID

• KEEP OUT OF REACH OF CHILDREN.
• If in eyes, immediately flush with running water for at least 15 minutes.
• If contact is made with skin wash thoroughly with soap and water or use recognised skin cleanser. Do not use solvents or thinners.
• If swallowed seek medical advice immediately and show the container or label. Do not induce vomiting.

For 24 hour medical emergency response service in Australia call 1800 883 254 and in New Zealand call 0800 000 096