White Knight Rust Guard^® Epoxy Enamel

How To Apply

1. PREPARATION

AEROSOL:

• Remove all rust and loose and flaking paint.
• Sand new metal, previously painted or glossy surfaces thoroughly.
• The surface must be clean, dry and free from dust, dirt, grease, oil, rust scale and other contaminants.
• Convert rusted steel and wrought iron surfaces with White Knight Rust Guard Rust Converter.
• Prime rusted steel and wrought iron with White Knight Rust Guard Metal Primer.
• Prime galvanised iron, ZINCALUME®* and non ferrous metals e.g. aluminium with White Knight Rust Guard True Bite or SLS Etch Primer.
• In highly corrosive conditions such as coastal areas prime steel and wrought iron with White Knight Rust Guard Metal Primer.
• Cover surrounding areas to protect from overspray.

BRUSH ON:

• Remove all rust and flaking paint.
• Sand new metal, previously painted or glossy surfaces thoroughly.
• Convert rusted surfaces with White Knight Rust Guard Rust Converter.
• The surface must be clean, dry and free from dust, dirt, grease, oil, rust scale and other contaminants.
• Prime galvanised iron, ZINCALUME® and non-ferrous metals e.g. aluminium with White Knight Rust Guard True Bite or SLS Etch Primer.
• In severe conditions, or for added protection to steel and wrought iron, prime with White Knight Rust Guard Metal Primer.

2. APPLICATION

AEROSOL:

• Shake can vigorously for 2 minutes before use and regularly during use.
• Adjust nozzle to desired spray pattern. Use the horizontal setting when spraying up and down and the vertical setting when spraying across.
• Hold the can upright approximately 15-20 cm from the surface.
• Press button firmly and spray with a smooth sweeping motion. Apply a pre-wetting mist coat followed by a full even coat, overlapping each spray pass. To prevent paint sagging, avoid spraying too close to the surface or spraying too heavily.
• Repeat if necessary.

Do not use when air or surface temperature is below 15°C or above 30°C

BRUSH ON:

• Stir thoroughly with a broad flat stirrer in a circular lifting motion for at least 5 minutes before use and continue to stir at regular intervals during application.
• No thinning is required for application by brush or roller. If spraying you may thin up to 10% with White Knight Rust Guard Solvent.
• Apply 2 coats by brush, roller or spray gun. For best results lightly sand between coats.

Do not use when air or surface temperature is below 10°C or above 30°C

*ZINCALUME® is a registered trademark of Bluescope Steel Limited.