White Knight^® Bench Top Protective Coating

How To Apply

1. PREPARATION

• Thoroughly clean surface with White Knight Tile & Laminate cleaner following label directions.

• Prime surface with White Knight Tile & Laminate primer following label directions
• Paint surface with White Knight Laminate Paint following label directions.
• Allow surface to dry for 24-48 hours before applying White Knight Bench Top Protective Coating. If allowed to dry for more than 48 hours, lightly sand before product application.
• Ensure surface is clean, dry and free from dust, dirt, grease, polish and other contaminants.

2. APPLICATION

• Stir Part A thoroughly with a broad, flat stirrer in a circular lifting motion.
• Add Part B. Mixing ratio is 3 Part A: 1 Part B by volume. IMPORATNT- incorrect mixing ratios will result in coating failure. Stir for 5 minutes.
• Apply coat with a foam  Do not spray. Lay off evenly for a consistent finish.
• After mixing, the product life is 1 hour maximum. Do not use product after pot life has been exceeded.

DO NOT USE AT TEMPRETURES BELOW 10°C OR ABOVE 35°C OR IN HIGH HUMIDITY.

Do not apply to damp surfaces or when rain is imminent as moisture contamination will prevent the curing process resulting in a soft finish.

3. COVERAGE

Approximately 20m² per litre per coat, depending on the nature of the surface

4. CLEAN UP

Clean equipment with water immediately after use.

5. CARE & MAINTENANCE

Bench tops coated with White Knight Bench Top Protective Coating can be cleaned with mild, non-abrasive household cleaners. Avoid use of abrasive cleaning products which can damage the finish.

6. SAFETY & FIRST AID

KEEP OUT OF REACH OF CHILDREN

• If swallowed do not induce vomiting. Wash out mouth thoroughly with water. If symptoms develop seek medical attention.
• If in eyes, hold eyelids apart and flush eyes continuously with running water. If symptoms develop and persist seek medical attention.
• Do not breathe vapour. If inhaled, remove affected person from area. If symptoms persist seek medical attention.
• If on skin, wash affected area thoroughly with soap and water. If symptoms develop seek medical attention.
• Ensure adequate ventilation during use and whilst drying.

For 24 hour medical emergency response service in Australia call 1800 883 254 and in New Zealand call 0800 000 096 

Caution:

DO NOT RESEAL THE CONTAINER ONCE PART A HAS BEEN MIXED WITH PART B.

7. ENVIRONMENT

• Do not pour unwanted paint down the drain.
• Keep unwanted paint in sealed containers for disposal via chemical waste collections. Solidified catalyzed paint may be disposed of a non-hazardous solid waste.
• Empty paint containers should be left open in a well ventilated area to dry out. When dry, recycle steel containers via steel recycling programs.
• Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check your local council first.