Quick Dry – True Bite

250ml, 500ml, 1L, 4L tin

Rust Guard Quick Dry True Bite is a technologically advanced primer that delivers optimum rust protection.

Ideal for priming all metal and as a base for both water and oil based topcoats.

Features:

  • Quick drying
  • Suitable for all types of metal
  • Touch dry in 20mins, re-coat after 1 hour
  • Excellent base for water and oil based topcoats
  • Ant-corrosive
  • Easy clean up with water
  • Exceptional adhesion
  • Ideal for fences, railings, gutters, roofs and gates

Suitable Surfaces

Rust Guard Quick Dry True Bite may be used on all metal surfaces.

Safety & First Aid

  • KEEP OUT OF REACH OF CHILDREN.
  • If swallowed, do not induce vomiting. Drink plenty of water and seek medical advice.
  • If in eyes, hold eyes open, flood with water for at least 15 minutes and seek medical advice.
  • Ensure adequate ventilation during use.

For 24 hour medical emergency response in Australia call 1800 883 254 and in New Zealand call 0800 000 096

Environment

  • Do not pour unwanted paint down the drain.
  • Keep unwanted paint in sealed containers for disposal via chemical waste collections.
  • Empty paint containers should be left open in a well ventilated area to dry out. When dry, recycle steel containers via steel recycling programs.
  • Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your council first.

 

Preparation

  • Sand new metal, previously painted or glossy surfaces thoroughly.
  • Remove all rust and flaking paint back to bare metal.
  • The surface must be clean, dry and free from dust, dirt, grease, oil, rust scale and other contaminants.

 

Application

  1. Stir thoroughly with a broad, flat stirrer in a circular lifting motion for at least 5 minutes before use and continue to stir at regular intervals during application.
  2. Apply 1 coat by brush, roller or spray gun. Apply 2nd coat if overcoating with a water based topcoat.

DO NOT USE AT TEMPERATURES BELOW 10°C, ABOVE 30°C OR IN HIGH HUMIDITY

 

Overcoating

If applying a water based topcoat, overcoat primer 2 hours after application.

If applying an oil based topcoat, overcoat primer 24 hours after application.

Coverage

Approximately 14m² per litre, depending on the nature of the surface.

Drying

Touch dry in 20 minutes. Re-coat after 1 hour.

Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied.

Clean Up

Clean brushes and equipment with water immediately after use.

 

FIND A STORE
Quick Dry – True Bite
Rust Protection