Bench Top Protective Coating

1L

White Knight Bench Top Protective Coating is a hard wearing clear coating that delivers a tough protective coating over painted laminate bench tops.

Ideal for protecting painted laminate bench tops from heat, chemicals and stains.

Features:

  • Tough, protective clear coating
  • Hard wearing
  • Low sheen
  • Low odour
  • Easy to apply
  • Water based, easy clean up

Suitable Surfaces

White Knight Bench Top Protective Coating may be applied over laminate bench tops that have been painted with White Knight Laminate Paint.

Interior use only.

Care and Maintenance

Bench tops coated with White Knight Bench Top Protective Coating can be cleaned with mild, non-abrasive household cleaners. Avoid use of abrasive cleaning products which can damage the finish.

Safety & First Aid

  • KEEP OUT OF REACH OF CHILDREN
  • If swallowed do not induce vomiting. Wash out mouth thoroughly with water. If symptoms develop seek medical attention.
  • If in eyes, hold eyelids apart and flush eyes continuously with running water. If symptoms develop and persist seek medical attention.
  • Do not breathe vapour. If inhaled, remove affected person from area. If symptoms persist seek medical attention.
  • If on skin, wash affected area thoroughly with soap and water. If symptoms develop seek medical attention.
  • Ensure adequate ventilation during use and whilst drying.

For advice, contact Poisons Information Centre (Australia 131 126; New Zealand 0800 764 766) or a doctor

Caution

DO NOT RESEAL THE CONTAINER ONCE PART A HAS BEEN MIXED WITH PART B.

Environment

  • Do not pour unwanted paint down the drain.
  • Keep unwanted paint in sealed containers for disposal via chemical waste collections. Solidified catalyzed paint may be disposed of a non-hazardous solid waste.
  • Empty paint containers should be left open in a well ventilated area to dry out. When dry, recycle steel containers via steel recycling programs.
  • Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check your local council first.

Preparation

  • Thoroughly clean surface with white Knight Tile & Laminate cleaner following label directions.
  • Prime surface with White Knight Tile & Laminate primer following label directions
  • Paint surface with White Knight Laminate Paint following label directions.
  • Allow surface to dry for 24-48 hours before applying White Knight Bench Top Protective Coating. If allowed to dry for more than 48 hours, lightly sand before product application.
  • Ensure surface is clean, dry and free from dust, dirt, grease, polish and other contaminants.

Application

  1. Stir Part A thoroughly with a broad, flat stirrer in a circular lifting motion.
  2. Add Part B. Mixing ratio is 3 Part A: 1 Part B by volume. IMPORATNT- incorrect mixing ratios will result in coating failure. Stir for 5 minutes.
  3. Apply coat with a foam ruler. Do not spray. Lay off evenly for a consistent finish.
  4. After mixing, the product life is 1 hour maximum. Do not use product after pot life has been exceeded.

DO NOT USE AT TEMPRETURES BELOW 10°C OR ABOVE 35°C OR IN HIGH HUMIDITY.

Do not apply to damp surfaces or when rain is imminent as moisture contamination will prevent the curing process resulting in a soft finish.

Pot Life

1 hour. Do not use product after pot life has been exceeded.

Coverage

Approximately 20m² per litre per coat, depending on the nature of the surface.

Drying

Touch dry in 1 hour, Re-coat after 8 hours using a fresh mix of product. Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied. Refrain from using bench top for 48 hours after application to allow the surface to cure. Avoid exposure to steam and condensation for 48 hours after painting. Light use only for the first 7 days.

Clean Up

Clean equipment with water immediately after use.

FIND A STORE