Reflect-All -

Reflect_all
White Knight Reflect-All is a revolutionary light reflective paint that can be applied to virtually any surface. The reflective microbeads capture, intensify and reflect light back to the source resulting in amazing night time visibility. Highlight potential hazardous objects, signs or equipment around your home or work site.
www.safetypaints.com.au
Suitable Surfaces

Suitable Surfaces

White Knight Reflect-All is the ultimate in visibility and safety at night and is perfect for residential, recreational, automotive and marine use. Suitable for use on fences and posts, curbing, rocks, trees, pet collars, steps, path and driveway. Vehicle door frames, bumpers, pushbikes and running shoes. Safety equipment and clothing, tanks and scaffolding, signs, life vests, boat railings, fishing gear, floats and buoys.
Preparation

Preparation

BEFORE SPRAYING
Cover all necessary areas to protect from overspray. It is essential to shake the can for at least one minute after mixing ball rattles to ensure product uniformity. Shake can occasionally during use. Do not use when the air or surface temperature is below 15°C or above 30°C or in excessive humidity.
Application Details

Application Details

Spray outside or in a well ventilated area away from fire and heaters. Test spray first on a small inconspicuous area to ensure surface compatibility and finish suitability. Hold the can upright approximately 15-20 cm from the surface. Press button firmly. Spray with a smooth sweeping motion. Overlap each spray pass. It is best to spray several light coats rather than a single heavy coat to allow the microbeads to protrude the surface. To prevent paint sagging, avoid spraying too close to the surface or spraying too heavy a coat.
Coverage

Coverage

Up to 1 - 1.5 metres per unit depending on the nature of the surface and the amount of overspray.
Drying Times

Drying Times

Dries to touch in 10 minutes. Drying times will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied
Clean Up

Clean Up

Overspray can be removed while still wet with Rust Guard Solvent or mineral turps.
Health and Safety

Health and Safety

Refer to Material Safety Data Sheet available by request on 131 686.
Pack Sizes

Pack Sizes

340g
Handyhint HANDY HINT

HANDY HINT

When spraying over previously painted surfaces, test spray first on a small inconspicuous area to ensure surface compatibility.
For a highly reflective effect, prime first with an appropriate grey primer and apply one light coat of Reflect-all. Test for reflective power then apply another coat if required.
Reflect-all works best if light coats are applied, this enables the reflective beads to protrude through the surface of the coating. Multiple coats without sufficient drying time will result in poor reflective effect.
To remove a child proof cap insert a screwdriver in the cap and lever it up
The horizontal setting is used when spraying up and down and press button until only gas escapes.
To clean nozzle after use and prevent blocking turn the can upside down and press button until only gas escapes.

Paint Effects

Reflect_all

© White Knight Paints 2005 | Privacy/Disclaimer | Site by Intervision Design