Preparation

Application Details

The unique anti slip ingredient may float to the surface on storage. DO NOT REMOVE. Stir thoroughly with a broad, flat stirrer in a circular lifting motion before use. Stir at regular intervals during application. Thin the first coat 20-30% with White Knight Rust Guard Solvent. Apply 2 coats. Do not thin the second coat. Apply using a brush or roller with a solvent resistant cover. Use an extension handle for ease of application. Do not use when the air or surface temperature is below 10°C or above 30°C or in damp conditions.

PROVIDE ADEQUATE VENTILATION DURING USE AND WHILE DRYING

Drying Times

Touch dry in 1 hour. Recoat after 2 hours. Drying times may be extended in low temperature and high humidity.

On driveways and garage floors, allow 72 hours before driving vehicles on the coated surface.

Coverage

Clean Up

Clean brushes and equipment with White Knight Rust Guard Solvent.

To remove oil or grease from White Knight Clear Sealer coated surfaces, use
a suitable concrete degreaser. Do NOT use thinners as this will remove the clear protective layer of White Knight Clear Sealer. Reapply White Knight Clear Sealer as required. For most other spillages, simply clean with detergent and wash with fresh water.

Do not pour unwanted paint down the drain. Keep unwanted paint in sealed containers for disposal via special chemical waste collections. Empty paint containers should be left open in a well-ventilated area to dry out. When dry, recycle steel containers via steel can recycling programs. Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.

Health and Safety

Refer to Material Safety Data Sheet available by request on 131 686.